|
Lu,
Isnt there space between the oil pan and flexplate
to get a wrench in? Is there 3 like a GM or more converter bolts? You may have
to do it after the heads are off and lay the engine on the side to get the last
one....Let me know what size the torque converter bolts are; If you need my
wrench i will send it.
Josh
----- Original Message -----
Sent: Sunday, February 29, 2004 8:31
PM
Subject: [BaadAssGremlins] Re: Lu's
Engine
But how can I get to all the bolts if the torque converter
is frozen?
Do I wedge the tool between the flex plate and the converter?
Will it
fit?
--- In BaadAssGremlins@xxxxxxxxxxxxxxx,
"Bandit" <formula421@f...>
wrote:
> Lu,
> Try to find a combination wrench that fitsthe
torque converter
bolts; see if you have one with a bit of an
offset.
> Put the closed end of the wrench on a torque converter bolt,
make
sure is on good and tap the wrench with a hammer in the
counterclockwise direction to loosen the bolt. Use this method until
you have all three loose. You may have to keep some tension on the
lower on the wrench with your fingers while you tap it up higher on
the wrench. This has worked for me...but if you try it, take your
time
and watch the fingers!
> Josh
|
Back to the Home of the AMC Gremlin