[BaadAssGremlins] Re: 360/401 Engine swap....
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[BaadAssGremlins] Re: 360/401 Engine swap....
- From: "Robert" <baddassgremlin@xxxxxxx>
- Date: Thu, 12 Apr 2007 16:15:50 -0000
Jim, I am just about ready to put my 401 back together also and it
sounds like you are going with the same parts as I did on the
block/pistons. My cam set up, I went with the comp cams magnum 292
kit with roller rockers. SS valves also. Edelbrock torker W/Edelbrock
780 carb.I have not done any research on the distributor yet, need to
do that.
Bob in MN
--- In BaadAssGremlins@xxxxxxxxxxxxxxx, Jim Shadwick <idahoamx@...>
wrote:
>
> Well finally got the 360 out of the Gremlin....it is now awaiting
its
> new bullet.....waiting to get the crank back from
> the balance shop and the pistons and rods assembled....should get
both
> tomorrow.....has taken a lot more time
> than I thought it would.... anyway....I am getting close to putting
the
> new engine together......
>
> All the 360 exterior parts are going on the 401.....so I will be
tearing
> it down in the morning....going to do a valve job
> on the heads.....They have been ported some already....with SS
> 2.08I/1.68 E valves....and milled around .035.....
> The 401 short block will of course have the factory forged
> crank/polished rods and 30 over Speed-Pro 2380
> forged pistons...CR will be around 9.8 to 1.....I kept the CR on
the low
> side because this may become a street cruiser
> motor in the AMX in the future......
>
> My plan is to have it up and running by the middle of next
> week.......ready for Test & tune on the 21st and
> the first Club race on the 27th.....
>
> Jim
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/BaadAssGremlins/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/BaadAssGremlins/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:BaadAssGremlins-digest@xxxxxxxxxxxxxxx
mailto:BaadAssGremlins-fullfeatured@xxxxxxxxxxxxxxx
<*> To unsubscribe from this group, send an email to:
BaadAssGremlins-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
Back to the Home of the AMC Gremlin