Re: [BaadAssGremlins] Water Pump Pulley Spacer

[themixtoo@xxxxxxx]

No, you didn't get an 'out of spec' pump. AMC used two different pumps, one was steel and one was aluminum. And you are supposed to replace steel w/steel and alum w/alum. If you mix them up, like I did, then I had a 1/16" spacer made out of brass and sandwiched it between two gaskets where it bolted to the timing cover. Everything alignes up ok now on my 360. Gary 'themix' 

-----Original Message-----
From: z_man401 <z_man401@xxxxxxxxx>
To: BaadAssGremlins <BaadAssGremlins@xxxxxxxxxxxxxxx>
Sent: Tue, Sep 20, 2011 7:35 pm
Subject: [BaadAssGremlins] Water Pump Pulley Spacer

 

Did i just buy an out of spec water pump(CAT)? or are there different pulleys that are only a 1/16 in off?

My crankshaft and P/S pulley are perfectly aligned but when I installed the water pump/fan pulley it needs a 1/16 spacer to perfectly align it.

Thanks

Bob

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___